Table of Contents
Advertisement
Verify RPD Association with Controller Profile
The rpd-ds 0 downstream-cable 3/0/1 profile 2 associates controller 3/0/1 with profile 2, which is a video
profile.
The core-interface te6/1/0 defines an auxiliary interface for this RPD. This auxiliary interface is used to
configure downstream sharing across line cards.
Verify RPD Association with Controller Profile
To verify the downstream controller profile association with RPD, use the show running-config | section
cable rpd <ID> command as shown in the following example:
Router#show running-config | section cable rpd RPD01
cable rpd toi-test1
type shelf
rpd-ds 0 max-carrier 150
rpd-ds 0 base-power 28
identifier 0000.1cbf.0000
core-interface Te2/1/0
principal
rpd-ds 0 downstream-cable 2/0/9 profile 0
rpd-event profile 0
Configure Downstream Sharing
This configuration is optional. DS sharing is used for multicast (MC) traffic. To configure downstream sharing,
use the following commands:
configure terminal
cable rpd RPD01
core-interface Te3/1/0
principal
rpd-ds 0 downstream-cable 3/0/1 profile 2
cable rpd RPD02
core-interface te3/1/0
principal
rpd-ds 0 downstream-cable 3/0/1 profile 2
Note
All RDPs in the same multicast group should have the same controller and profile association.
Configure Controller in Fiber Node
To configure the controllers in fiber-node, use the cable fiber-node command, as given in the following
example:
cable fiber-node 113
downstream Downstream-Cable 8/0/0
upstream Upstream-Cable 8/0/1
Verify CM RPD Association
To verify the RPD associated with the cable modem, use the show cable modem rpd command as shown in
the following example:
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
62
Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Advertisement
Table of Contents
