Static Routes - Siemens SCALANCE XM-400 Configuration Manual
Industrial ethernet switches
Hide thumbs
Also See for SCALANCE XM-400:
- Configuration manual (960 pages) ,
- Operating instructions manual (80 pages) ,
- Instructions manual (60 pages)
Table of Contents
Advertisement
● Inside Global Port
Shows the port that will be assigned to the Inside Global Address.
● Description
Shows a a description for the port translation.
Procedure
To create a static port translation, proceed as follows:
1. Select the a NAT interface from the "Interface" drop-down list:
2. In "Inside Local Address" enter the actual address of the device that should be reachable
from external.
3. Select a service.
4. Depending on your selection in the "Service" drop-down list specify the start, end and inside
global port.
5. Select a protocol.
6. Enter a description for the port translation.
5.6.4
Static Routes
Static route
On this page, you create the static IPv4 routes.
Description of the displayed values
The page contains the following boxes:
● Destination Network
Enter the network address of the destination that can be reached via this route.
● Subnet Mask
Enter the corresponding subnet mask.
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
Configuring with Web Based Management
5.6 The "Layer 3 (IPv4)" menu
351
Advertisement
Table of Contents
