Commands In The Vlan Configuration Mode (Transparent Bridgee); Ip Address - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
6.1.7

Commands in the VLAN configuration mode (Transparent Bridgee)

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the vlan $$$ command to change to this mode.
When doing this, you need to replace the $$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can be
found in the relevant sections.
● If you exit the VLAN Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the end command, you return to the Privileged
EXEC mode.
6.1.7.1

ip address

Description
With this command, you assign an IP address.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip address <ip-address> {<subnet-mask>| / <prefix-length(0-32)>}
The parameter has the following meaning:
Parameter
ip-address
subnet-mask
prefix-length
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
210
Description
IP address
Subnet mask
Decimal representation of the mask as
a number of "1" bits
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Specify a valid IP address.
Enter a valid subnet mask.
0 ... 32
Configuration Manual, 07/2017, C79000-G8976-C361-06