Commands For User-Defined Math Functions; Table - Keithley SourceMeter 2400 User Manual

®
2400 Series SourceMeter User's Manual
Figure 8-2
Connections for voltage coefficient tests
MEAS
EDIT V I
DISPLAY
0 1
TOGGLE
LOCAL REL
POWER
6 7
DIGITS SPEED
User-defined math functions
In addition to the pre-defined math functions, you can also define your own functions by
using appropriate remote commands (user-defined math functions are not available from
the front panel). The following paragraphs summarize the basic commands for user-
defined functions and also list a basic programming example. See
subsystems," for more details on user-defined math functions.
Commands for user-defined math functions

Table 8-5

summarizes the commands for user-defined math functions. To define a math
function:
1. If desired, assign units to the calculation result using :CALC:MATH:UNIT. Units
is stored for the calculation.
2. Assign a name to the expression (using up to 10 ASCII characters) using the
:CALC:MATH:NAME "user-name" command.
3. Define the expression using the :CALC:MATH:DEFine or
:CALC:MATH:EXPRession command. The new expression is the one that will be
presently selected.
4. Enable the math function by sending :CALC:STATE ON.
5. Turn on the output by sending :OUTP ON, then send :INIT to trigger the unit.
6. Request the data with the :CALC:DATA? query.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4 WIRE INPUT/
SENSE OUTPUT
HI
1100V
5V
PEAK PEAK

SourceMeter
LO
SOURCE
Ω
FCTN V I
RANGE
2 3 4 5 EDIT
AUTO
TERMINALS
FILTER LIMIT TRIG SWEEP
ON/OFF
+/- RANGE FRONT/
8 9
REAR
STORE RECALL CONFIG MENU EXIT ENTER
OUTPUT
Relative and Math 8-9
Resistor
1100V Under
PEAK
Test
250V
! PEAK
Section 18, "Calculate