Dell S6100 Configuration Manual page 1728

brief
vrf vrf-name
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
8.3.19.0
8.3.10.0
8.3.2.0
Usage Information The following describes the show vrrp ipv6 command.
Line starting
with
GigabitEthernet...
VRF
State: master...
1728 Virtual Router Redundancy Protocol (VRRP)
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel, and then a
number.
• For a VLAN interface, enter the keyword vlan, and then a number from 1 to 4094.
(OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
Enter the keyword vrf then the name of the VRF to view IPv6 VRRP groups
corresponding to that VRF.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series.
Description
Displays the interface, VRRP group ID, and network address. If the interface is not
sending VRRP packets, 0.0.0.0 appears as the network IP address.
VRF instance to which the VRRP group interface belongs.
Displays the interface's state:
• Na/If (not available)
• master (MASTER virtual router)