Dell S6100 Configuration Manual page 1730

Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
8.4.2.1
8.4.1.0
8.3.19.0
8.3.7.0
8.3.2.0
Usage Information
The VRRP group only becomes active and sends VRRP packets when you configure a link-local virtual IP address.
When you delete the virtual address, the VRRP group stops sending VRRP packets.
•
•
Related Commands
•
1730 Virtual Router Redundancy Protocol (VRRP)
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
The range of valid VRID values on the E-Series when VRF microcode is loaded in CAM
changed from 1 to 15.
Introduced on the E-Series, C-Series, and S-Series.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series.
When you do not load the VRF microcode in the CAM, the VRID for a VRRP group is the same as the VRID
number configured with the vrrp-group or vrrp-ipv6-group commands.
When you load the VRF microcode in the CAM, the VRID for a VRRP group equals 16 times the vrrp-group
or vrrp-ipv6-group vrid number, plus the ip vrf vrf-id number. For example, if you load the VRF
microcode and you configure the VRRP group as 10 in VRF 2, the VRID for the VRRP group is (16 x 10) + 2, or
162. This VRID value is used in the lowest byte of the virtual MAC address of the VRRP group and is also used
for VRF routing.
NOTE: For all routers to interoperate, configure the same VRID on neighboring routers (Dell Networking
or non-Dell Networking) in the same VRRP group.
virtual-address — assigns up to 12 virtual IP addresses per VRRP group.