Stack Enable - Allied Telesis x310-26FT Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING

STACK ENABLE

stack enable
Overview This command is used on a stackable stand-alone switch to manually turn on the
VCStack feature.
This command can also be run on a switch that has previously been removed from
a stack (by using the no variant of this command) and return it to stacking
operation.
The no variant of this command removes a selected stack member switch, as
specified by the <stack-ID> selection in the command syntax, from the virtual
chassis stack.
stack enable
Syntax
no stack <stack-ID> enable
Default The VCStack feature is enabled by default. The feature automatically starts when
hardware is present.
Mode Global Configuration
Usage When stack enable is entered, the stack virtual-mac is automatically enabled. Using
virtual-mac is required in order to minimize disruption on failover.
Running the no variant of this command will remove the selected stack member
from the stack. At this point the removed member will act as a stand-alone master
and will disable all of its ports. The switch can then only be accessed via its console
port. If the command is run on the master then all current members of the stack will
be disabled.
To return the switch to stack membership, first connect to the switch via its console
port, then run the stack enable command. Then save the configuration and run
the
ordinary member.
If the switch was previously the stack master, you might want to return it to its
original stack master status. To do this you must run the
This time—because the switch is now a stack member—the command will reboot
the whole stack and result in a new master election.
Note the following when using the no stack <stack-ID> enable command:
•
CAUTION
capability of the stack.
C613-50103-01 REV A
™) C
TACK OMMANDS
Parameter Description
<stack-ID>
Stack member number, from 1 to 8.
reboot command. This will reboot the switch and it will re-join the stack as an
If the specified stack-ID is not used by any current stack member, the
command will be rejected.
: Disabling a stack member can significantly degrade the throughput
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
reboot command again.
1936