Ip Dhcp Snooping - Allied Telesis x310-26FT Command Reference Manual

DHCP S C
NOOPING OMMANDS

IP DHCP SNOOPING

ip dhcp snooping
Overview Use this command to enable DHCP snooping on one or more VLANs.
Use the no variant of this command to disable DHCP snooping on the VLANs.
Syntax ip dhcp snooping
no ip dhcp snooping
Default DHCP snooping is disabled on VLANs by default.
Mode Interface Configuration (VLANs)
Usage For DHCP snooping to operate on a VLAN, it must:
•
•
•
Any ACLs on a port that permit traffic matching DHCP snooping entries and block
other traffic, will block all traffic if DHCP snooping is disabled on the port. If you
disable DHCP snooping on particular VLANs using this command, you must also
remove any DHCP snooping ACLs from the ports to maintain connectivity (no
access-group
Examples To enable DHCP snooping on VLANs 2 to 4, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable DHCP snooping on the switch, use the command:
awplus#
awplus(config)#
awplus(config-if)#
Related ip dhcp snooping trust
Commands
service dhcp-snooping
show ip dhcp snooping
C613-50103-01 REV A
be enabled on the particular VLAN by using this command
be enabled globally on the switch by using the
command
have at least one port connected to a DHCP server configured as a trusted
port by using the ip dhcp snooping trust
command).
configure terminal
interface vlan2-vlan4
ip dhcp snooping
configure terminal
interface vlan2-vlan4
no ip dhcp snooping
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
service dhcp-snooping
command
1856