Switch Provision (Stack) - Allied Telesis x310-26FT Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING
( )
SWITCH PROVISION STACK

switch provision (stack)

Overview This command enables you to provide the configuration for a new stack member
switch prior to physically connecting it to the stack. To run this command, the stack
position must be vacant. The selected hardware type must be compatible existing
stack hardware.
Use the no variant of this command to remove an existing switch provision.
switch <stack-ID> provision {x310-26|x310-50}
Syntax
no switch <stack-ID> provision
Mode Global Configuration
Usage Note that although the syntax appears to allow provisioning on up to 8 stackable
switches, in practice a maximum of 4 are configurable. Normally the stack
members would be numbered 1 to 4, and so the command could be run to
provision any stack member within this range; and we advise this procedure. In
effect, the syntax then becomes:
switch <1-4> provision {x310-26|x310-50}
However, you could number the stack units with any numbers between 1 and 8.
For example you could number your four stack members 1, 2, 7 and 8. In this case
you could provision any of the stack members within this range. We advise against
numbering your stacks in this way.
Examples To provision an x310-26 switch as stack member 3, use the following commands:
awplus#
awplus(config)#
To remove the provision of the x310-26 switch as stack member 3, use the
following commands:
awplus#
awplus(config)#
Related show provisioning (stack)
Commands
show stack
C613-50103-01 REV A
™) C
TACK OMMANDS
Parameter Description
<stack-ID>
Stack member number, from 1 to 8.
provision
Provides settings within the stack configuration ready for a
specific switch type to become a stack member.
x310-26
Provision a 26-port x310 switch.
x310-50
Provision a 50-port x310 switch.
configure terminal
switch 3 provision x310-26
configure terminal
no switch 3 provision
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1949