Stack Management Vlan - Allied Telesis x310-26FT Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING

STACK MANAGEMENT VLAN

stack management vlan
Overview Use this command to configure the stack management VLAN ID.
Use the no variant of this command to change the stack management VLAN ID
back to the default (VLAN ID 4094).
Syntax stack management vlan <2-4094>
no stack management vlan
Default VLAN ID 4094
Mode Global Configuration
Usage The management VLAN is used for high speed communication between stacked
units. This command enables you to change the ID of this VLAN.
The default stacking management VLAN ID is 4094, which is the last configurable
VLAN ID in the switch.
The stack management VLAN is created and configured automatically so that the
stack VLAN cannot be used in the stack's VLAN configuration commands (such
asawplus(config-vlan)# vlan <Stack management VLAN ID>).
The management VLAN should only be changed if the default stack VLAN ID needs
to be used in the stack's VLAN configuration.
If the management VLAN ID is changed by this command, you can use the no
variant of this command to change it back to default value.
CAUTION
variant of this command to change it back to the default value.
When the command is entered, the updated management VLAN configuration will
take effect once the stack is restarted.
Examples To set the management VLAN to 4000, enter the following commands:
awplus#
awplus(config)#
To reset the management VLAN back to the default (4094), enter the following
commands:
awplus#
awplus(config)#
Related stack management subnet
Commands
C613-50103-01 REV A
™) C
TACK OMMANDS
Parameter Description
<2-4094>
Stack management VLAN ID.
: If the management VLAN ID is changed by this command, you can use the no
configure terminal
stack management vlan 4000
configure terminal
no stack management vlan
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1939