Stack Priority - Allied Telesis x310-26FT Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING

STACK PRIORITY

stack priority
Overview Use this command to change a specific stack member's master-election priority.
stack <stack-ID> priority <0-255>
Syntax
no stack <stack-ID> priority
Mode Global Configuration
Usage This command is used to change the value of a specific stack member's
master-election priority. If the specified stack-ID is not used by any current
stack member, the command will be rejected.
The election criteria selects the stack member with the lowest priority value to
become the stack master. Where two stack members both have the same lowest
priority value, then the stack member with the lowest MAC address will be elected
as master.
NOTE
master. In order to force a master re-election after the new priority value is assigned,
use reboot stack-member <master's ID> to reboot the current stack master, a new
stack master will then be elected based on the new priority values.
Example To change the priority of stack member 2 to be 3, use the command:
awplus#
awplus(config)#
Validation show stack
Command
C613-50103-01 REV A
™) C
TACK OMMANDS
Parameter Description
<stack-ID>
Stack member number, from 1 to 8.
priority
The stack member's election priority value.
<0-255>
The stack member's new priority value. The lowest value is assigned
the highest priority. The default is 128.
: Assigning a new priority value will not immediately change the current stack
configure terminal
stack 2 priority 3
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1940