Openflow - Allied Telesis x310-26FT Command Reference Manual

O F C
PEN LOW OMMANDS

OPENFLOW

openflow
Overview Use this command to specify a port as a data plane port. The ingress and egress
traffic on the data plane port become controlled by the OpenFlow Controller. A
data plane port number is assigned to the port automatically.
Use the no variant of this command to cancel the setting of a port as a data plane
port. After entering the no variant of this command, you must restart the switch.
openflow
Syntax
no openflow
Default All the ports are non-data plane ports by default.
Mode Port Interface mode
Example To specify port1.0.3 as a data plane port:
awplus#
awplus(config)#
awplus(config-if)#
Related show openflow config
Commands
C613-50103-01 REV A
configure terminal
interface port1.0.3
openflow
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1897