Ipv6 Address - Allied Telesis IE220 Series Manual

IP 6 C
V OMMANDS
6
IPV ADDRESS

ipv6 address

Overview Use this command to set the IPv6 address of an interface. The command also
enables IPv6 on the interface, which creates an EUI-64 link-local address as well as
enabling RA processing and SLAAC.
To stop the device from processing prefix information (routes and addresses from
the received Router Advertisements) use the command no ipv6 nd
accept-ra-pinfo.
To remove the EUI-64 link-local address, use the command no ipv6
eui64-linklocal.
Use the no variant of this command to remove the IPv6 address assigned and
disable IPv6. Note that if no global addresses are left after removing the IPv6
address then IPv6 is disabled.
ipv6 address <ipv6-addr/prefix-length>
Syntax
no ipv6 address <ipv6-addr/prefix-length>
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Usage notes Note that the device keeps link-local addresses until you remove them with the no
variant of the command that established them. See the
more information.
Also note that the device keeps the link-local address if the global address is
removed using a command other than the command that was used to establish
the link-local address. For example, if a link local address is established with the
ipv6 enable
command.
Examples To assign the IPv6 address 2001:0db8::a2/64 to the VLAN interface vlan2, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50644-01 Rev B
Parameter
<ipv6-addr/prefix-
length>
command then it will not be removed using a no ipv6 address
configure terminal
interface vlan2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Specifies the IPv6 address to be set. The IPv6
address uses the format X:X::X:X/Prefix-Length. The
prefix-length is usually set between 0 and 64.
Note that your switch will not accept prefix lengths
greater than 64.
ipv6 address 2001:0db8::a2/64
ipv6 enable command for
898