Ipv6 Address - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

IP 6 C
V OMMANDS
6
IPV ADDRESS

ipv6 address

Overview Use this command to set the IPv6 address of an interface. The command also
enables IPv6 on the interface, which creates an EUI-64 link-local address as well as
enabling RA processing and SLAAC.
To stop the device from processing prefix information (routes and addresses from
the received Router Advertisements) use the command no ipv6 nd
accept-ra-pinfo.
To remove the EUI-64 link-local address, use the command no ipv6
eui64-linklocal.
Use the no variant of this command to remove the IPv6 address assigned and
disable IPv6. Note that if no global addresses are left after removing the IPv6
address then IPv6 is disabled.
ipv6 address <ipv6-addr/prefix-length>
Syntax
no ipv6 address <ipv6-addr/prefix-length>
Mode Interface Configuration for a VLAN interface.
Examples To assign the IPv6 address 2001:0db8::a2/64 to the VLAN interface vlan2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the IPv6 address 2001:0db8::a2/64 from the VLAN interface vlan2, use
the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 enable
Commands
ipv6 eui64-linklocal
show running-config
show ipv6 interface brief
show ipv6 route
613-50157-01 Rev C
Parameter
<ipv6-addr/prefix-
length>
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
Specifies the IPv6 address to be set. The IPv6
address uses the format X:X::X:X/Prefix-Length. The
prefix-length is usually set between 0 and 64.
ipv6 address 2001:0db8::a2/64
no ipv6 address 2001:0db8::a2/64
617