D.3 Etsi Platform Defaults - Cisco ONS 15454 DWDM Installation And Operation Manual

Appendix D Network Element Defaults

D.3 ETSI Platform Defaults

The following sections give the NE defaults for the 15454 ETSI platform. To see defaults for the 15454
ANSI platform, see the
D.3.1 ETSI Card Default Settings
The tables in this section list the default settings for each DWDM, TXP, and MXP card. For all other
cards, including optical, electrical, Ethernet, and Fibre Channel, refer to the Cisco ONS 15454 SDH
Reference Manual.
Cisco provides user-configurable defaults for the Cisco ONS 15454 cards, including:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
August 2005
"D.2 ANSI Platform Defaults" section on page
Soak Time—All cards. The length of time that elapses between an AINS port receiving a valid signal
and when it automatically changes to in-service status.
Port State (config state)—All cards. Sets the port to one of the five available administrative states
(unlocked; locked,disabled; locked,maintenance; unlocked,automaticInService), depending on
whether you need ports in or out of service.
SF BER Level—TXP and MXP cards. Defines the signal fail bit error rate.
SD BER Level—TXP and MXP cards. Defines the signal degrade bit error rate.
Enable Sync Messages—MXP cards. Enables synchronization status messages (S1 byte), which
allow the node to choose the best timing source.
Send Do Not Use—TXP and MXP cards. Sends a DUS message on the S1 byte when enabled.
Payload Type—TXP and MXP cards. Defines the type of client signal.
Termination Mode—TXP and MXP cards. Defines the type of termination (line, section, or
transparent).
ALS Mode—TXP and MXP cards. Sets the automatic laser shutdown feature to one of four available
states (disabled, auto restart, manual restart, manual restart for test).
ALS Recovery Interval—TXP and MXP cards. Sets the automatic laser shutdown recovery time
interval.
ALS Recovery Pulse Width—TXP and MXP cards. Sets the automatic laser shutdown recovery
pulse signal width.
FEC—TXP and MXP cards. Enables or disables the FEC monitoring on the optical transport
network.
G.709 OTN—TXP and MXP cards. Enables or disables the ITU-T G.709 monitoring on the optical
transport network.
FEC Thresholds—TXP and MXP cards. Set the performance monitoring parameters for gathering
FEC performance data and detecting problems early.
Optical Thresholds—TXP and MXP cards. Set the performance monitoring parameters for gathering
physical optics performance data and detecting problems early.
OTN Thresholds—TXP and MXP cards. Set the performance monitoring parameters for gathering
OTN trunk-side performance data and detecting problems early.
PM Threshold settings—All cards. Set the performance monitoring parameters for gathering
performance data and detecting problems early.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
D.3 ETSI Platform Defaults
D-2.
D-57