Avaya S8700 Maintenance Manual page 2559

VAL-BD (Voice Announcements over LAN Circuit Pack)
LAN cable
The TN2501AP circuit pack does not include cables to connect the circuit pack to
your LAN. The following table lists the cable category and connection port.
Ethernet
connection speed
10 Mbps
100 Mbps
Maintenance Commands
The following table lists several VAL-related maintenance commands and how to
use the command for troubleshooting.
Table 8-702. VAL maintenance commands
Command
test board
test port
test mo
busyout board
release board
busyout port
release port
reset board
reset val
status data-module
status firmware download
list sys-link
status sys-link
555-233-143
Cable Connection description
Category 3 Connects through the RJ45 jack (note #2 in
Figure 8-109),
Category 5 Connects through the RJ45 jack (note #2 in
Figure 8-109),
Use this command to
Test both circuit pack- and port-level maintenance.
Test any of the ports on the VAL circuit pack.
Test either of the 2 MOs on the VAL circuit pack.
Curtail activity on the circuit pack before resetting it (reset board).
Resume activity on the circuit pack after busying out the VAL circuit
pack or ports on it (busyout board or busyout port).
Isolate a specific port usually during troubleshooting.
Resume activity after busying out a port on the VAL circuit pack
(busyout port).
Re-initialize the circuit pack in the system and upload announcement
file information.
Reset the circuit pack if it is in the insane state and to override
querying the board to determine whether an announcement autosave
is in process.
Obtain general information about the data-module connection to port
33 on the VAL circuit pack
Obtain information about a demand or scheduled firmware download.
Generate a list of administered links and the general status of each.
Generate a detailed status report for a specific administered system
link.
Continued on next page
Issue 1 May 2002 8-1837