Maintenance-Object Repair Procedures
Other hardware
To establish LAN connections the TN2501AP circuit pack requires a
Backplane Adapter that attaches to the Amphenol connector behind the
cabinet, corresponding to the TN2501AP integrated announcement circuit
pack slot.
LAN cable
Backplane Adapter
The following figure shows the Backplane Adapter (label reads IP Media
Processor).
Figure Notes
1. Amphenol connector attaches to the
back of the switch cabinet,
corresponding to the TN2501AP circuit
pack's slot.
Figure 8-109. Backplane Adapter (Comcode 848525887)
8-1836
Issue 1 May 2002
that attaches to the Backplane Adapter.
3
1
addfipm2 KLC 083000
2
2. RJ-45 LAN cable connection
10 Mbps uses Category 3 cable.
100 Mbps uses Category 5 cable.
3. This connector is not used for VAL.
555-233-143