Toyota T100 1996 Service Manual page 2015

INSTALLATION
1. INSTALL COMPRESSOR
(a) Install the compressor with 4 bolts.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
(b) Connect the connector.
2. CONNECT DISCHARGE AND SUCTION HOSES
Connect the both hoses with the 2 bolts.
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
NOTICE:
Hose should be connected immediately after the caps have been removed.
HINT:
Lubricate 2 new O−rings with compressor oil and install the hoses.
3. INSTALL AND CHECK DRIVE BELT
(See page AC−16, AC−14)
4. INSTALL ENGINE UNDER COVER
5. 5VZ− FE Engine Models:
INSTALL PS PUMP SET BOLT AND NUT
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
6. CONNECT NEGATIVE (−) TERMINAL CABLE TO BATTERY
7. EVACUATE AIR FROM REFRIGERATION SYSTEM
8. CHARGE SYSTEM WITH REFRIGERANT
Specified amount: 650 ± 50 g (22.92 ± 1.76 oz.)
9. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.
10. INSPECT A/C OPERATION
1996 TOYOTA T100 (RM449U)
AIR CONDITIONING − COMPRESSOR AND MAGNETIC CLUTCH
AC−45
AC081−02