Acura Integra 1998 Service Manual page 878

7 .
9 .
8 .
Set the rear window upright on the hatch, then
center it in the opening. Make alignment marks
across the rear window and body with a grease pen-
cil at the four points shown.
R e m o v e t h e r e a r w i n d o w .
Center and glue the side rubber dams to the inside
Iace of the rear window, as shown, to contain the
adhesive during installation.
N O T E :
a Glue the side rubber dams, using the printed dots
a s a g u r d e .
a Be careful not to touch the rear window where
a d h e s i v e w i l l b e a p p l i e d .
a Mask off surrounding surlaces betore applying
p r i m e r .
ALIGNMENT MARK
REAR WINDOW
1 O . I n s t a l l t h e r e a r w i n d o w t r i m .
With a sponge, apply a light coat oI glass primer
a r o u n d t h e e d g e o f t h e r e a r w i n d o w , t h e n l i g h t l y
wipe it off with gauze or cheesecloth.
N O T E I
a Do not apply body primer to the rear window, and
do not get body and glass primer sponges mlxed
u p .
a Never touch the primed surlaces with Your hands.
lf you do, the adhesive may not bond to the rear
window properly, causing a leak after the rear
w i n d o w i s i n s t a l l e d .
a Keep water, dust, and abrasive materials away
lrom the primed surface.
' t 1 .
NOTE: Apply the glass primer,
usjng the printed dots as a
gLrde,
7///r1 , eppY slass p mer here.
M O L D I N G
1 5 6 6 1
{ 0 . 6 i n l
(0.08 in)
UPPER
SEAI 2 mm
1 5 m m
{O.6 in}
GLASS
l O . 5 i n )
MOLDING
REAR WINDOW
2 0- 6 3