Table of Contents
Advertisement
ATF Pump
Inspection
' t .
Install the ATF pump gears and ATF pump driven
gear shaft in the main valve body.
N O T E :
a Lubricate all parts with ATF during inspecting.
a Installthe ATF pump driven gear with its grooved
and chamfered side facing up as shown.
2 .
Measure the side clearance of the ATF pump drive
and driven gears.
ATF Pump Gears Side {Radial} Clearance:
Standald (Newl: Drive geal
O . 2 1 O 0 . 2 6 5 m m ( O . O 0 8 3 O . O 1 0 4 i n )
Dfiven geal
0 . 0 7 O
0 . 1 2 5 m m ( O . O 0 2 8 O . 0 0 4 9 i n )
ATF PUMP
DRIVEN GEAR
Grooved and chamfered side
facing up.
ATF PUMP
DRIVE GEAR
ATF PUMP
DRIVEN GEAR
Inspect teeth for wear and damage,
lnspect teeth for wear and damage-
3. Remove the ATF pump driven gear shatt, and mea-
sure the thrust clearance oI the ATF pump driven
gear-to-main valve body.
ATF pump Drive/Driven Gearthlust (Axiall Clearance:
Standard lNew):
0 . O 3 - 0 . 0 5 m m ( 0 . 0 O 1 0 . 0 0 2 i n )
Selvice Limit:
O . O 7 m m { 0 . 0 0 3 i n )
STRAIGHT EDGE
14-'|, 2 3
Advertisement
Table of Contents
Troubleshooting
