Table of Contents
Advertisement
Power Steering Pump
Replacement
NOTE: Before disconnecting the hoses from the pump,
place a suitable container under the vehicle.
1. Remove the belt by loosening the pump adjusting
bolt, mounting bolts and nuts.
2.
Cover the Ay'C compressor with several shop towels
to protect it from spilled power steering fluid,
11 N.m
11.1 kgf.m, 8 lbl ft)
PUMP
INLET HOSE
(Low-pressure)
O.RING
Replace.
ADJUSTTNG
BOLT
?UMP MOUt'lTlNG BOLTS
2a N.m (2.a kgf.m, 17 lbf.ftl
t
7 .
Disconnect the pump inlet hose and the pump out-
let hose (High-pressure) trom the pump, and plug
them.
NOTE: Take care not to spill the fluid on the body
or parts. Wipe off any spilled fluid at once.
Remove the pump mounting bolts, then remove the
pump.
NOTE:
. Do not turn the steering wheel with the pump
removed,
. Cover the opening of the pump with a piece of
tape to prevent foreign materiai from entering
the oumo.
Connect the pump inlet hose and the pump outlet
h o s e ( H i g h - p r e s s u r e ) . T i g h t e n t h e p u m p f i t t i n g s
securelv,
Loosely install the pump in the pump bracket with
the mounting bolts, nuts and adjusting bolt.
Installthe DumD belt.
CAUTION:
. Mako suro that the power staering belt is prop-
erly positioned on the pulleys.
a Do not gst powor 9t99ring fluid or greas€ on the
power steering bclt or pulley facos. Clesn off any
tluid or grea3a botoro installation
POWER STEERING BEI-T
Adjust the pump belt (see page 17-20).
Fill the reservoir to the upper level line (see page
'11.211.
8.
a
1 7 - 3 5
Advertisement
Table of Contents
Troubleshooting
