Table of Contents
Advertisement
Back-up Lights
Test
Manual Transmission:
NOTE: Check the No. 19 (7.5 A) fuse in the underdash
fuse/relay box before testing.
Test the back-up light switch by placing the shift
lever in reverse and turning the ignition switch to ON
f l r ) .
lI the back-up lights do not go on, check the back-
up light bulbs in the taillight assembly.
lI the fuse and bulbs are oK, disconnect the connec-
tor from the back-up light switch.
2 .
3 .
l .
SWITCH 25 N.m (2.5 kgf-m,
'18 lbf-Ir)
This washer must
always be replaced
for the switch to
tunction properly
and 10 prevent oil
teaKs,
terminal side
4. With the shift lever in reverse, check for continuity
between the A and B terminals with the switch in-
stalled.
There should be continuity.
a It there is no continuity, replace the switch (see
s e c t i o n 1 3 ) .
a lf there is continuity, but the back-up lights do not
go on, check for:
- P o o r g r o u n d { G 5 0 3 }
An open in the wire
A
6
Automatic T.ansmission:
NOTE: Check the No. 19 (7.5 A) fuse in the under-dash
fuse/relay box before testing.
2 .
'1 .
Test the back-up light swirch by shifting the shift
lever to @ and turning the ignition switch ON (ll).
lf the back-up lights do not go on, check the back-
up light bulbs in the taillight assembly.
l f t h e f u s e a n d b u l b s a r e O K , d i s c o n n e c t t h e 1 4 P
connector from the A,/T gear position switch (back-
up light switch).
View from terminal side
A
B
C
D
E
F
G
Move the lever back and torth at the E
position
without touching the push button, and check for
continuity between the C and D terminals. There
should be continuity within the range of free play of
the shilt lever.
a lf there is no continuity within the range of free
play, adiusl the position ot the A/T gear position
switch {see section 14}.
a lf there is continuity, but the back-up lights do not
g o o n , c h e c k t o r :
- Poor ground {G5O3)
- An open in the wire
Advertisement
Table of Contents
Troubleshooting
