Acura Integra 1998 Service Manual page 579

18. Install the sub-shaft assembly in the transmission
housing {see page 14-142],.
'19.
Install the reverse idler gear and gear shaft holder
( s e e p a g e 1 4 - 1 5 8 ) .
20. Install the differential assembly in the torque con
verter housrng.
21. Assemble the mainshaft and countershaft sub-
assembly, then install them together in the torque
converler noustng.
22. Turn the shilt fork so the large chamlered hole is fac-
ing the fork bolt hole, then installthe shift tork with
the reverse selector and torque the lock bolt. Bend
the lock tab against the bolt head.
SHIFT FORK
23. Install the reverse gear with the collar and needte
bearing on the countershaft.
24. Align the spring pin of the control shaft with the
transmission housing groove by turning the control
shaft.
25. Place the transmission housing on the torque con-
verter housing with a new gasket and the three
d o w e l p i n s .
CONTROL
TRANSMISSION HOUSING
lnstall the transmission housing mounting bolts along
with the transmission hanger and the connector
bracket, then torque the bolts in two or more steps
in the sequence shown.
TOROUE: rt4 N'm (4.5 kgt.m, 33 lbt.lt)
TRANSMISSION
26.
LOCK WASHER
Replace.
6 x 1 . 0 m m
4 t{.m
( 1 . 4 k g f . m , 1 0
e
Large chamfered hole
/ -'K\,,
a
1 4 - 1 6 3