Table of Contents
Advertisement
Steering Column
Installation (cont'dl
CAUTION:
a All SRS wire harness€s are covored with yollow insu-
lation. B€fors you disconnect any part of an SRS wire
harness. disconnoct the airbag connoctois.
a Whenever the ignition switch is ON (lll, or has beon
turned OFF for less than throo minutos, be caleful not
to bump the SRS unit; ths airbags could accidsntslly
deploy and caus€ damago or iniuries.
a For additionalpracautions, reter to the SRS sub-section
in section 23,
1. Slip the upper end of the steering joint onto the col-
umn shaft (line up the bolt hole with the flat on the
shaft). and loosely install the upper steering joint
bolt
UPPER STEERTNG
JorNT BoLT
STEERING
JOINT
Slip the lower end of the steering joint onto the pin-
i o n s h a f t . L i n e u p t h e b o l t h o l e w i t h t h e g r o o v e
around the shaft) and loosely installthe lower bolt.
NOTE:
.
B e s u r e t h a t t h e l o w e r s t e e r i n g j o i n t b o l t , i s
securely in the groove in the steering g€arbox
p r n r o n .
. Before tightening the steering joint bolts, pull on
the steering ioint to make sure that the steering
ioint is fullY seated.
LOWER STEERING JOINT BOLT
F i n 6 l t o r q u e :
22 N.m
12.2 kgf.m, 16 lbf.ft)
17-32
I n s t a l l t h e s t e e r i n g c o l u m n w i t h t h e f l a n g e n u t s ,
then installthe column holder and flange bolts.
T i g h t e n t h e u p p e r a n d l o w e r s t e e r i n g j o i n t b o l t s
loosely installed in steps'l and 2.
STEERING COLUMN
FLANGE BOLTS
22 N'm
(2.2 kgt'm' 16lbf'ftl
Install the steering joint cover with the clamps and
c l l P .
CLIP
\
{
Advertisement
Table of Contents
Troubleshooting
