Table of Contents
Advertisement
E8r Clamp Type Boot Eand Installation:
Csnada model outboard joi]|t bands
-1. Install the ear clamp boot band by aligning the
tabs with holes in the band.
EAR CLAMP BAND
Replace.
Close the ear portion of the band with a com-
mercially available boot band pincers.
BOOT AAND PINCERS
(Commercially available)
Oetiker 1098 or equivalent
POSTION
Measure the clearance between the closed ear
portion of the band.
S i a n d a r d : 0 - 3 m m ( 0 - 0 . 1 2 i n )
lf the band's, clearance is not within the standard,
close the ear portion of the band further.
NOTE:
. Make sure the band does not move.
. Remove any grease remaining in the surround-
ing surfaces.
1 6 - 1 3
Advertisement
Table of Contents
Troubleshooting
