Table of Contents
Advertisement
Gharging System
Rear Bearing Replacement
Alternator Reassembly
MITSUBISHI:
1. Pull off the rear bearing.
Make sure the tips of the bearing puller jaws are
thin enough to fit between the bearing and the
s l i p r i n g s .
Do not reuse the bearing.
BEARING PULITR
SLIPRINGS
(Commorciallyav6ilable)
Use a hand press to install the new bearing. Apply
pressure only on the inner race to avoid damaging
the bearing.
23-114
L
:
-
REAR BEARING
1 . P u s h t h e b r u s h e s i n , t h e n i n s e r t a p i n o r d r i l l b i t
(about 1.8 mm diameter)to hold them there.
ARUSHES
Heat the rear bearing seat in the rear housing as
described on page 23-12. After heating, continue
immediately with assembling before the rear bear-
ing seat cools completely.
Put the rear housing/stator assembly and drive-end
housing/rotor assembly together, tighten the four
t h r o u g h b o l t s a n d p u l l o u t t h e p i n .
THROUGH BOLT
* ,
DRIVE.END
HOUSI'{G/ROTOR
ASSEMBLY
REAR
STATOR ASSEMSLY
After assembling the alternator. turn the pulley by
hand to make sure the rotor rotates smoothlv and
without noise.
BRUSH AOCCSS HOI,"€
Advertisement
Table of Contents
Troubleshooting
