Acura Integra 1998 Service Manual page 665

Troubleshooting
Fluid Leaks
Check the gearbox assembly for oil leaks carefully, Oil can leak out of various points, depending on location of the
faulty oil seals/seal rings. Check the following before removing the gearbox from the frame.
Stoo.ing Gearbox
Replace the valv€ oil seal from
the valvo houging.
Leaking from the oil seal on the
top of the valve housing.
Roplace the valve oil seal from
the pinion shaft.
Leaking trom cylinder 6nd into
l€ft ti6-rod boot,
B€place tho cylindgr ond seal on
the gear housing side.
Replaco th€ cylindor end seal on
ths cylinder end side.
Leaking from cylinder end into
right tie-rod boot.
Leaking from the thaft upper end
section or pin ongagement sgc-
tion ofth6 Dinion shaft
RoDlace tho valve bodv unit.
I
I
Tighten connector. lf it€ still leak-
ing. replace th€ lin€, cylinder or
valve housing.
Leaking lrom cylind6r line A or B
conn6ction {Et flare nut).
Leaking caused by a damaged
cylinder line A or B.
Replace cylinder line A or B.
Tightgn tho connector. ll its still
leaking, r€place the hos€, joint
fitting or valv€ housing.
L e a k i n g f r o m o u t l e t l i n e a n d
r e t u r n l i n e j o i n t f i t t i n g o n t h e
valv6 body unit (at flare nut).
1 7 - 1 6