Acura Integra 1998 Service Manual page 603

Bearing Replacement
t
a
NOTE: Check the ball bearings for wear and rough ro-
tation. lf bearings are OK, removal is not necessary.
'1. Remove
the ball bearings using a standard bearing
puller and bearing separator as shown.
BEARING PULLER
(Commercially
available)
BALL BEARING
2 .
lnstall new ball bearings using the special tool as
shown.
NOTE: Drive the bearings squarely until they bot-
tom against the carrier.
DRIVER, 40 mm l.D.
07746-00301OO
BALL BEARING
' t .
2 .
Remove the differential assembly.
Remove the 80 mm shim from the transmission
housrng.
80 mm SHIM
TRANSMISSION
HOUSING
3.
Remove the oil seal from the transmission housinq.
4. Remove the oil seal from the clutch housinq.
OIL SEAL
Replace.
Seal
Removal
1 s - 5