Table of Contents
Advertisement
Ball Joint Boot Replacement
Remove the boot set ring.
CAUTION: Do not contaminata the boot installa-
tion seqtion with grease.
Pack the interio. of the boot and lip with grease.
BALL PIN TAPERED SECTION
BOOT INSTAI-LATION SECTION EOOT INSTALLATION SECTION
Wipe offthe grease,
Wipe off the greaso.
3.
Wipe the grease off the sliding surface of the ball
pin and pack with fresh grease.
CAUTION:
o Keep grease olf ths boot instsllation 3ostion and
the tapored $ction ot ths ball pin.
. Do not sllow du3t, dirt. or othor foreign materi-
als to €nter tho boot.
4.
Install the boot in the groove of the boot installation
section securelv, then bleed air.
Install the upper and lower ball joint boot set rings
using the specialtools as follows:
Lower ball joint: Adjust the special tool with the
adjusting bolt until the end of the tool aligns with
the groove on the boot, Slide the set ring over the
tool and into position.
U p p e r b a l l j o i n t : H o l d t h e t o o l o v e r t h e b a l l j o i n t .
then slide the set ring over the tool and into posi-
tron.
BALL JOINT
BOOT CLIP
GUIDE
UPPER BALL
JOINT BOOTi
o?GAG - SD4(,700
LOWER EALL
JOINT BOOT:
0797/r - SA507q)
BOLT
Adlst the depth by
turning the boh.
CAUnON: Aftor installing the booi, check the ball
pin tspersd 3oction tor gr9as9 contaminaiion and
wipe it if nece$ary.
1 8 - 1 9
Advertisement
Table of Contents
Troubleshooting
