Table of Contents
Advertisement
t
Disassembly/Reassembly
Remove the ATF guide cap by pushing the sub-shaft
inside the transmission housing.
Remove the 1st-hold clutch assembly by pulling the
sub-shaft, then remove the sub-shaft.
Install new O-rings on the sub-shaft.
NOTE: Wrap the shaft splines with tape to prevent
damaging the Orings,
Place the sub-shaft in the transmission housing and
install the 1st-hold clutch assembly.
Install new ATF guide cap using the specialtools as
s h o w n .
NOTE: Install the ATF guide cap in the direction
s h o w n .
ORIVER
TTACHMENT,
3 2 x 3 5 m m
0 7 7 4 6 - O 0 1 0 1 0 0
CLUTCH
ASSEMBLY
14-143
Advertisement
Table of Contents
Troubleshooting
