Acura Integra 1998 Service Manual page 1251

Side Marker/Turn Signal/Hazard Flasher System
Turn Signal/Hazatd Relay Input Test
\
t
S R S c o m p o n e n t s a r e l o c a t e d i n t h i s a r e a . R e v i e w t h e
SRS component locations, precautions, and procedures
in the SRS section (23) before performing repairs or ser-
1 .
Remove the turn signal/hazard relay from the under-
dash fuse/relay box.
Inspect the relay and socket terminals to be sure they
are all making good contact.
a lf the terminals are bent, loose or corroded, repair
them as necessary, and recheck the system.
a lf the terminals look OK, make the tollowing in
put tests at the socket.
lf a test indicates a problem, find and correct
the cause, then recheck the system.
- lf all the input tests prove OK, the turn sig-
nallhazad relay must be faulty; replace jt.
2 .
UiTDER.DASH FUSE/RELAY
aox
TURN SIGNAL/
HAZAND RELAY
No. Telminal Test condition Test: Deaired result
Possible cause it result is not obtained
l g n i t i o n s w i t c h O N ( l l )
and turn signal switch
in right or left; connect
the B terminal to the L
r e r m t n a t ,
Check for continuity to ground:
There should be continuity.
. P o o r g r o u n d ( G 2 0 1 , G 4 0 1 )
. An open in the wire
l g n i t i o n s w i t c h O N ( l l )
and hazard warning
switch OFF
Check for voltage to ground:
There should be battery voltage
. B l o w n N o . 2 0 ( 1 0 A ) f u s e i n t h e
under-dash fuse/relay box
. Faulty hazard warning switch
. An open in the wire
lgnition switch OFF and
hazard warning switch
O N
Check lor voltage to ground:
There should be battery voltage.
. Blown No. 43 ('1 0 A) f use in the
under-hood fuse/relay box
. Faulty hazard warning switch
. An open in the wire
Hazard warning switch
is ON; connect the B
terminal to the L
r e r m t n a t .
Hazard lights should come on.
. Poor ground (G201, G301, G401,
cs03)
. Faulty hazard warning switch
. An open in the wire
Right or left turn signal lights
should come on.
. Faulty turn signal switch
. An open in the wire