Table of Contents
Advertisement
8. Set the rear window, then center it in the opening.
Make alignment marks across the rear window and
body with a grease pencil at the tour points shown.
9 . R e m o v e t h e r e a r w i n d o w .
O. With a sponge, apply a light coat of glass primer
around the edge of the rear window as shown, then
lightly wipe it off with gauze or cheesecloth.
N O T E :
a Do not apply body primer to the rear window, and
do not get body and glass primer sponges mixed
u p .
a Never touch the primed surfaces with your hands.
lf you do, the adhesive may not bond to the rear
window properly, causing a leak atter the rear
window is installed.
a Keep water, dust, and abrasive materials away
trom the primed surface.
'fu5
t appty gtass p.im€r he.e.
All around.
'10 mm
{0.4 in)
ALIGNMENT MARK
...\
S
;-1\-\
1 1 . W i t h a s p o n g e , a p p l y a l i g h t c o a t o J b o d y p r i m e r t o
the original adhesive remaining around the rear win-
dow opening flange. Let the body primer dry tor at
l e a s t 1 O m i n u t e s .
N O T E :
a Do not apply glass primer to the body, and be
carelul not to mix up glass and body primer
s p o n 9 e s .
a Never touch the primed surfaces with your hands.
//ffi:
Apgly body primer here.
'16 mm
{O.63 in)
6 m m
{ 0 . 2 3 i n }
6 m m 1 0 . 2 3 i n l
1 6 m m 1 0 . 6 3 i n )
Thoroughly mix the adhesive and hardener together
on a glass or metal plate with a putty knife. Follow
the instructions that came with the adhesive.
N O T E : C l e a n t h e p l a t e w i t h a s p o n g e a n d a l c o h o l
b e f o r e m i x i n g .
Before filling a cartridge, cut the end of the nozzle
a s s h o w n .
1 6 m m { 0 . 6 3 i n }
1 0 m m { 0 . 3 9 i n }
Cut nozzle end
Advertisement
Table of Contents
Troubleshooting
