Table of Contents
Advertisement
6,
Install the new SRS unit.
o ^ l - o
9.8 N.m 11.0 kgf m, 7.2
Use a Torx T30 bit.
I
TORX BOLTS
9.8 N.m 11.0 kgl.m, 7.2 lbf'ftl
Use a Torx T30 bit.
7 .
Connect the SRS main harness l8P connector to the
SRS unit; push it into position until it clicks.
I n s t a l l t h e S R S u n i t c o v e r s ( r i g h t a n d l e f t ) M a k e
sure the covers snap together in the middle.
8.
, l
\
1 0 .
Reconnect the driver's airbag 2P connector to the
cable reel 2P connector, then reinstall the access
panel on the steering wheel.
Reconnect the front passenger's airbag connector
to the SRS main harness.
Reconnect the battery positive cable, then the nega-
tive cable.
After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (ll); the SRS
indicator light should come on for about six seconds
and then go off.
1 1 .
12.
Advertisement
Table of Contents
Troubleshooting
