Table of Contents
Advertisement
1 2 . A d j u s t c l e a r a n c e " 8 " a s f o l l o w s .
)^
d
\
"8" {see pase 20-42}
(6\r
:\D
\crnss
1 L o w e r t h e g l a s s 1 O m m ( 0 . 3 9 i n ) .
2 P u s h t h e g l a s s o u t w a r d l O m m ( 0 . 3 9 i n ) , t h e n
push the inside stabilizers against the glass light-
l y . F a s t e n t h e i n s i d e s t a b i l i z e r s .
N O T E : C h e c k t h a t t h e g l a s s m o v e s s m o o t h l y .
i
i l
INSID€
STAEILIZER
BOLT
8 x 1 . 2 5 m m
22 N.m 12.2 kgl.m,
16 tbt ftl
3 Loosen the lo"knrt, "nd turn the adjusting bolt
until the clearance "B" is within the specilied
v a l u e .
Adiusting
Bolt
Clockwise
T o p E d g e
of Glass
Counter-
c l o c k w i s e
LOCKNUT
ADJUSTING BOLT
20-44
Doors
Glass Adjustment (cont'd)
out
\
LOCKNUT
REGULATOR
ADJUSTING BOLT
NOTE: Turn the front and rear adjusting bolts the
same amount to keep the regulator parallel with the
seating sur{ace ot the door.
After tightening the adjusting bolts, make sure that
the ends of the adjusting bolts still project out of the
locknuts.
4 Align the front sash with the glass using the ad-
justing bolt at the bottom of the lront sash.
5 Move the glass up and down to seat it, then
m e a s u r e c l e a r a n c e " B " a t t h e d e s i g n a t e d l o
c a t i o n s .
6 Measure clearance "H" again to make sure it
is still within the specified limirs at the desig,
nated locations.
NOTE: Repeat the above steps until the correct
clearances are obtained.
Top Edge
o f G l a s s
GLASS
ADJUSTING BOLTS
I
Advertisement
Table of Contents
Troubleshooting
