Rear Damper
Lower the rear suspension and position the damper
with the welded nut pointed toward the front of the
vehicle.
DAMPER
2.
Loosely install the two flange nuts.
H a t c h b a c k :
Sedan:
lnstallation
. ',.?7
, : . . r 9 \ , i
r '..\rEY
FLANGE NUTS
10 x 1.25 mm
Tighten these nuts in step 7 on the next page.
1 8 - 4 0
3.
Install the wheel sensor wire bracket.
N O T E : B e c a r e f u l w h e n i n s t a l l i n g t h e s e n s o r s t o
avoid twisting wires.
Raise the rear suspension with a floor iack until the
vehicle just lifts off the safety stand.
@
The floor jack must be securely posi-
tionod or personal iniury may result.
5 . I n s t a l l t h e d a m p e r m o u n t i n g b o l t a n d t h e f l a n g e
bolt, then tighten the bolts.
N O T E : T h e d a m p e r m o u n t i n g b o l t a n d t h e f l a n g e
b o l t s h o u l d b e t i g h t e n e d w i t h t h e d a m p e r u n d e r
vehicle load.
FLANGE EOLT
10 x 1.25 m.n
54 N.m (5.5 kgf m, 40 lbt.ftl
FLANGE BOLT
10 x 1-25 mm
54 N.m ls.s kgf m, 40 lbtft)
6.
Tighten the three wheel sensor wire bracket bolts
{for vehicles with ABS).
9.8 N.m {1.0 kg{.m, 7.2 lbtftl
BOLTS