Table of Contents
Advertisement
\a
t
Clutch LoWHigh Prossuro Moasursment
@
wnire t6sting, be carelul of the rotating
front whaols.
- 1. Allow the front wheels to rotate freelv.
2. Remove the cable end of the throttle control cable
trom the throttle control drum.
NOTE: Do not loosen the locknuts, simply unhook
the cable end.
THROTTLE CONTROL DRUM
-3.
Start the engine and let it idle.
-4.
Shitt to @
position.
5. Slowly move the throttle linkage to increase engine
rpm until pressure is indicated on the A/T pressure
g a u g e .
Then release the throttle linkage, allowing the en-
gine to return to an idle, and measure the pressure
reading.
6. With the engine idling. lift the throttle controldrum
up approximately
'l12
of its possible travel and in-
crease the engine rpm until pressure is indicated
on the gauge, then measure the highest pressure
reading obtained.
- 7. Repeat steps 5 and 6 for each clutch pressure be-
ing inspected.
d
Q^--,'.-
THROTTLE CONTROL DRUM
( c o n r ' d )
1 4 - 1 0 1
Advertisement
Table of Contents
Troubleshooting
