Table of Contents
Advertisement
Unev€n or rough steering.
Adjust rack guid€ (see page 17-21).
It the problem is not corrocted by
adjusting the rack guid€, replace
the g€a.box.
Adjust b6ll tension. Ropl6ce the
b6lt, it necossary {s€e p€ge 17-20).
lfth€ engine stalls when the wheel
i s t u r n e d w h i l e t h e v e h i c 1 6 i s
stopped or moving at low speed.
adjust idl6 sp6od (s€e s€ction 111.
ldle spoed low or €rratic.
Check powsr st6oring fuid lovel. lf
the lovel is exceggively low, ch6ck
tor leaks in the svstem. Add fluid
to the sD6cilied l6v6l,
Air in r€gervoir, or check powsr
steering fluid lovel.
lf fluid level is OK, chock O-rings
and seals on both 6nds ot the
pump suction hose. and the P/S
pump housing mating surfaces
and tho oumo shaft oil seal for
suction lgakr. Roplaco parts as
n6c6ssary.
P u m p b € l t s l i p p i n g o n p u l l o y
(pump stops momentarily).
Adiust b6lt t€nsion {s6e page '17-
20) or r6olac€ b€lt.
Chock if pump pressure is normal
and the gauge needle trav€l is 500
kPa (5 kgl/cm' , 71 psi) or lesB.
Ch€ck the flow control valvo if the
no€dl€ trav€l oxco€ds 500 kPa {5
kg7cml, 71 p6i). lf the flow control
valve is normal. roplace the pump
as an assemDtv.
Install the power st66ring pr6s-
su16 gaug6. Close th6 prossure
control valve lully and m6asure
the pump prossure (see page'17-
22t.
Ste€ring wheol kicks back
during wide turns.
7 - 13
Advertisement
Table of Contents
Troubleshooting
