Acura Integra 1998 Service Manual page 698

r a
NOTE:
. Clean the disassembled parts with a solvent and dry them with compressed air. Do not dip the rubber parts in a sol-
venr,
. Always replace the O-rings and rubber seals with new ones before assembly,
. Apply recommended power steering fluid to the parts indicated in the assembly procedures.
. Do not allow dust, dirt, or other foreign materials to enter the power steering system.
. Use the appropriate specialtools where necessary.
FLANGE BOLT
20 N.m 12.0 kgf.m, 14 lbl.ftl
VALVE HOUSING
CYLINDER LINE B
26 N.m 12.7 kgf.m, 20
VALVE OIL SEAL
Replace.
SLEEVE SEAL RINGS
Replace.
st"cEvE
VALVE SEAL
Replace.
WAVE WASHER
VALVC SEAL RING
Replace.
O-RING
Replace.
PINION SHAFT
RACK GUIDE SCREW
LOCKNUT \
cEARBoxHousrNc \b
SPRING
f,ACK GUIDE
BACKUP RING
Replace.
GEAR HOUSING
CYLINDER END
Replace.
CYLINDER END SEAL
Replace.
O.RING
Replace.
I
o0'
STEERING RACK
PISTON SEAL RING
Replace.
CYLINDER END
69 N.m {7.0 kgtm,51 lbtftl
{cont'd}