Table of Contents
Advertisement
a
Brake
Pedal
Pedal Height
1 .
D i s c o n n e c t t h e b r a k e s w i t c h c o n n e c t o r , l o o s e n t h e
brake switch locknut, and back oll the brake switch
u n t i l i t i s n o l o n g e r t o u c h i n g t h e b r a k e p e d a l .
2.
Turn up the jloor mat, and measure the pedal height
from the lett srde center of the pedal pad.
PUSHROD
ERAKE SWITCH
LOCKNUT
LOCKNUT
swtTcH
BRAKE PEOAL PAO
I
MEASURING
POINT
Standard Pedal Hsight (wiih ftoor m8t removedl:
M/T: 160 mm {6 5/16 in}
A/T: 165 mm (6 1/2 in)
3.
Loosen the pushrod locknut, and screw the pushrod
in or out with pliers until the standard pedal height
from the floor is reached. After adjustment, tighten
the locknut firmly. Do not adjust the pedal height
with the pushrod depressed.
{1.5 kgf.m, 11 lbt.ftl
1 9 - 5
Screw in the brake switch until its plunger is fully
depressed (threaded end touching the pad on the
pedal arm). Then back off the switch 1/4 turn to
make 0.3 mm (0.01 in) of clearance between the
threaded end and the pad. Tighten the locknut firm-
ly. Connect the brake switch connector.
CAUTION: Make sure that the brake lights go ofl
when the pedal is released.
5. Check the brake pedal free play as described below.
Pedal Free Play
1. Stop the engine, and inspect the play on the pedal
pad by pushing the pedal by hand.
Free Play: 1 - 5 mm {l/16 - 3/16 in)
2.
lf the pedal free play is out of specification, adjust
the brake switch. tf the pedal free play is insuffi_
cient, it may result in brake drag.
PEDAL PAD
Advertisement
Table of Contents
Troubleshooting
