Acura Integra 1998 Service Manual page 395

1 . Measure the clearance between the thrust shim and
1st gear.
Standard:
0.045 - 0.205 mm (0.0018 - 0.0081 in)
Service Limit:0.265 mm {0.0104 in}
3.
Measure the clearance between 2nd and 3rd gears.
Standard:
0.07 - 0.14 mm {0.003 - 0.006 inl
Service Limit: 0.20 mm (0.008 in)
4.
lf the clearance exceeds the service limit, measure
the thicknesses of 2nd gear and the spacer collar.
2ND GEAR
lf the clearance exceeds the service limit, measure
the thicknesses of 1st gear and the thrust shim.
lST GEAR
Standard: 31./t5 - 31.50 mm (1.238 - 1.2i10 in)
THRUST SHIM
Standard: 1.945 - 1.955 mm (0.0766 - 0.0770 inl
SPACER COLLAR
Stand.rd: 29.07 - 29.09 mm 11.1'+4 - 1.1,15 inl
lf the thicknesses of 1st gear and the thrust shim
a r e l e s s t h a n t h e s t a n d a r d , r e p l a c e t h e m w i t h
new ones,
lf the thicknesses of 1st gear and the thrust shim
are within the standard, replace the 1sv2nd syn-
chro hub with a new one,
lf the thicknesses of 2nd gear and the spacer col-
lar are less than the standard, reDlace them with
new ones.
lf the thicknesses of 2nd gear and the spacer col-
lar are within the standard, replace the 1sv2nd
synchro hub with a new one.
THRUST SHIM
Engine Type B 1 8 C 1 , 8 1 8 C 5 8 1 8 8 1
Standard
2a.92 - 28.97 mm
( 1 . 1 3 9 - 1 . 1 4 1 i n )
34.62 - 34.67 mm
( 1 . 3 6 3 - 1 . 3 6 5 i n )
Service Limit 28.8 mm
( 1 . 1 3 i n )
3 4 . 5 m m
( 1 . 3 6 i n )