Acura Integra 1998 Service Manual page 932

zril
H
Seat Belts
I
I
Front Seat Belt Replacement
CAUTION: Ch€ck the tront seat belts for dsmage, and
replace them if necessary. Be car€ful not to damage
them during removal and installation.
Hatchback
1. Slide the front seat forward fully.
2. Remove.
. Rear shelf (see page 20-91)
. Rear trim panel (see page 20-92)
. Rear seat {see page 20-110}
. Side trim panel {see page 20-92)
3. Pull back the carpet as necessary, remove the bolts,
then remove the middle floor gusset.
>:8oh locldons
A>, 5
€ t
8 r 1 . 2 5 m m
p zz trt'm tz.z rgf.m,
e
16 bf.ftl
10 x t.25 mm
:ta N.m 13.9 kgf.m,
26 tbrftl
8>, 3
4.
Remove the front seat belt from the belt quide.
BELT GUIDE
5.
Remove the anchor cover and anchor cap.
UPPER ANCHOR
EOLT
7/16 - 20 UNF
32 N.m (3.3 kgt m,
24 rbf.ftl
RETRACTOR
MOUNTI]IIG
BOLT
6 r 1 . 0 m m
9.8 N.m 11.0 tgf.m,
1.2 tblJftl
PROTECTOR
LOWER ANCHOR
BOLT
7 / 1 6 - 2 0 U N F
32 N.m {3.3 kg{.m,
24 tbf.ftl
ANCHOR CAP
AL-
RETMCTOR BOLT
7/16 - 20 UtrtF
32 N.m 13.3 lgi.m,
2'a tbt ftl
7 .
Remove all the anchor bolts and the retractor bolt.
remove the retractor mounting bolt, then remove
the front seat belt and retractor.
Installation is the reverse of the removal procedure.
NOTE:
o Check that the retractor locking mechanism func-
I|ons.
. Make sure you assemble the washers and collars
on the upDer and lower anchor bolts as shown.
. B e f o r e i n s t a l l i n g t h e a n c h o r b o l t s , m a k e s u r e
there are no twists or kinks in the front seat belt.
RETRACTOR