Acura Integra 1998 Service Manual page 1247

Brake
Brake
Lights
Switch Test
High Mount Brake Light Replacement
\
t
2 .
t .
3 .
lf the brake lights do not go on. check the No. 52
{20 A) fuse in the under-hood fuse/relay box, and
t h e b r a k e l i g h t b u l b s i n t h e t a i l l i g h t a s s e m b l y a n d
high mount brake light.
lf the fuse and bulbs are OK, disconnect the 2P or
4P connector from the brake switch.
Without c.uise
control syst€m
Wilh cruise
control sYstem
Check for continuity between the B and C terminals.
There should be continuity with the brake pedal
p u s n e o .
a lf there is no continuity, replace the switch or ad-
just pedal height (see section '19).
o It there is continuity, but the brake lights do not
go on, inspect for:
Poor ground (G5O3)
An open in the wire
A B
FS-A
l t - - L t
l , t !
, Z - \
C D
- / B
ran
l - l
t l
tLatl
\ c
(LED typel
1. Remove the tour screws and the high mount brake
light, then disconnect the connectors.
TAILGATE SPOILER
HIGH MOUNT BRAKE LIGHT {tED TYPE}
23-190