Table of Contents
Advertisement
59.
Apply steering grease to the circumference of the
rack end housing.
Coat the rack end groove and inside of the boot
with silicone grease.
-Cl
STEERTNG
GREASE
SILICONE GBEASE
Coat the sliding
surface ofthe rack
end.
60. l n s t a l l t h e b o o t s i n t h e r a c k e n d w i t h t h e t u b e
clamps.
NOTE: Install the boots with the rack in the straight
ahead position (right and left tie-rods are equal in
length).
RACK END
TUBE CLAMP
17-57
o t .
Adjust the air tube fitting position ot the boots by
turning it as shown below.
C o n n e c t t h e a i r t u b e b e t w e e n t h e r i g h t a n d l e f t
boot, then install the clips on the cylinder line B as
snown.
Installthe righi clip
in this position.
(cont'd)
mrn 11.57 - 1.97 inl
Advertisement
Table of Contents
Troubleshooting
