Table of Contents
Advertisement
\
\
\
Mainshaft
J
J
Disassembly/lnspection/Reassembly
N O T E :
a Lubricate all parts with ATF during reassembly.
a Inspect the thrust needle bearings and the needle bearings for galling and rough movement.
a Before installing the O-rings, wrap the shatt splines with tape to prevent damaging the O-rings.
a Locknut has left-hand threads.
LOCKNUT IFLANGE NUTI
1 9 x 1 . 2 5 m m
78 N.m (a.0 kgf.m, 58 lbl'ltl
R e p l a c e .
L e f t h a n d t h r e a d s
THRUST WASI{€R
4TH GEAR
CONICAL SPRING WASHER
Replace.
1ST CLUTCH
ASSEMBLY
O-RINGS
Replace.
THRUST WASHER
THRUST NEEDLE
EEARING
NEEDLE EEARING
1ST GEAB
MAINSHAFT
Check splines for excessive
wear ano oamage,
Check bearing surface for scoring,
scratches and excessive wear.
NEEDLE BEARINGS
THRUST NEEDI-E
BEARING
4TH GEAR COLLAR
2ND/4TH CLUTCH
BEARING
THRUST NEEDLE
BEARING
lST GEAR
COLLAR
O-RINGS
Replace.
THRUST WASHER, 36.5 x 55 mm
Selective part.
THBUST NEEDLE
BEARING
2ND GEAR
lnstall the sealing ring
mating laces as shown-
SET FING
NE€DLE BEARING
J
1 4 - 1 3 3
Advertisement
Table of Contents
Troubleshooting
