Table of Contents
Advertisement
Power Door Locks
Control Unit Input Test
1 . Remove the driver's door panel (see section 20).
Disconnect the 14P connector from the control unit,
Inspect the connector and socket terminals to be
sure they are all making good contact.
a lf the terminals are bent. loose or corroded, repair
them as necessary, and recheck the system.
a lf the terminals look OK, make the following in-
put tests at the connector.
- lf any test indicates a probiem, find and cor-
rect the cause, then recheck the system.
- lf all the input tests prove OK, the control unit
must be faulty; replace it.
14P CONNECTOR
View from wire side
23-244
Advertisement
Table of Contents
Troubleshooting
