Table of Contents
Advertisement
4 .
Tap on the transmission housing side of the ditferen-
tial assembly with the special tool to seat the
differential assembly in the torque convener housing.
o .
Measure the clearanc; between the thrust shim and
outer race of the ball bearing in the transmission
n o u s r n g .
S T A N D A R D : O - 0 . 1 5 m m ( O - O . O 0 6 i n )
It out of limits. select a new thrust shim from the
tollowing table:
THRUST SHIM, 80 mm
NOTE: Il the thrust shim-to-ball bearing outer race
clearance measured in step 5 is within the standard,
it is not necessary to perform steps 7 and 8.
Remove the transmission housing.
Replace the 2.50 mm {0.098 in) thrust shim with
the one of the correct thickness selected in step 6.
Install the transmission housing (see sectjon 14).
7 .
L
Part Number
Thickness
9 0 4 r 4 - 6 8 9 - 0 0 0
9 0 4 1 5 - 6 8 9 - 0 0 0
9 0 4 1 6 - 6 8 9 * 0 0 0
9 0 4 1 7 - 6 8 9 - O O O
9 0 4 1 8 - 6 8 9 - O 0 0
9 0 4 1 9 - P H 8 - 0 0 0
2 . 5 0 m m ( 0 . 0 9 8 4 3 i n
2 . 6 0 m m ( 0 . 1 0 2 3 6 i n
2 . 7 0 m m ( O . 1 0 6 3 0 i n
2 . 8 0 m m { O . 1 1 O 2 4 i n
2 . 9 0 m m { O . 1 1 4 1 6 i n
3 . O O m m ( O . l
' 1 8 1
1 i n
9 .
Advertisement
Table of Contents
Troubleshooting
