Acura Integra 1998 Service Manual page 708

Install and tighten the gearbox mounting bolts.
NOTE: After installing the gearbox, check the air
t u b e c o n n e c t i o n s f o r i n t e r f e r e n c e w i t h a d j a c e n t
parts.
58 N.m 15.9 kgl.m, 43 lbf.ftl
Connect the power steering fluid lines to the valve
body unit.
7 .
38 N.m {3.9 kgt m, 28 lbf.ftl
RETURN HOSE
PUMP OUTI.TY HOSE
(High-pressure)
37 N.m (3.8 kgf.m, 27 lbt.ftl
Center the steering rack within its stroke.
Before connecting the steering joint, perform the
lollowing operation.
. Center the cable reel by first rotating it clockwise
(approximately two turns) until the arrow mark
on the label points straight up,
Slip the lower end of the steering ioint onto the pin-
i o n s h a f t { l i n e u p t h e b o l t h o l e w i t h t h e g r o o v e
around the shaft), and tighten the lower bolt.
NOTE:
. Connect the steering shaft and pinion with the
cable reel and steering rack centered.
. Be sure that the lower steering joint bolt is se-
curely in the groove in the steering gearbox pin-
i o n .
o lf the steering wheel and rack are not centered,
r e o o s i t i o n t h e s e r r a t i o n s a t l o w e r e n d o f t h e
steering joint.
(cont'd)
LOWER BOLT
22 N.m {2.2 kgf.m, 16 lbf.ft,
1 7 - 5 9