Acura Integra 1998 Service Manual page 745

)
Installation
Typ€ R Model:
NOTE;
. Any bolts or nuts connected to rubber mounts or bushings should be tightened with the vehicle on the ground.
.
"L" is stamped on the left lower arm and "R" is stamped on the right lower arm.
.
"l UP LS" is stamped on
the left upper arm and "l UP RS" is stampedon the right upper arm.
. The right and left compensator arms are symmetrical. Install then with the "1 Up" mark facesing forward
. After installing the suspension arm, checkthe rearwheel alignmentand adjustitif necessary(see page 18-4).
8 mm BOLT
22 N.m (2.2 kgl m, 16 lbt.ftl
STABILIZER BAR
Align the stabilizer mark
with end of stabilizer bushing.
-Ar
UPPEB ARM
rz tot+,t \
\
.d'
. Ja)
, n [
_oY
t \
a
stLtcoNE
GREASE
BUSHING
ADJUSTING BOLT
IFLANGE BOLT}
l0 x 1.25 mm
6,4 N.m {6.5 kgt m,
FLANGE BOLT
'10 x 1.25 mm
5,[ N.m 15.5 kg[.m. 40 lbt.ftl
STABILIZER BUSHING
FLANGE BOLT
10 x 1.25 mm
FLANGE BOLT
10 x 1.25 mrn
39 N.m (,r.0 kgf.m.29 lbtftl
5/a N.m 15.5 kgl.m, a0
COMPENSATOR AFM
UPPER ARM
TRAILING ARM
FLANGE BOLT
10 x 1.25 mm
54 N.m 15.5 kgf.m, .{) lbf.ftl
..-
SILICONE
.4@i
cREAsE
COMPENSATOR
ARM BUSHING
FLANGE BOLI
10 r 1.25 mm
6,4 N.m (6.5 kgl.m, 47 lbf.Itl
FLANGE BOLT
12 x 1.25 mm
6a N.m 16.5 kgl.m, a7 lbf.ftl
,
ror"orr /
l0 x 1.25 mm
39 N.m 14.0 kgf.m, 29 lbt.ftl
FLANGE BOLT
8 x 1.25 mm
30 N.m 13.1 kgt m, 22 lbf.ftl
..-
SILICONE
.@ll GREASE
FLANGE BOLT
10 x 1.25 mm
54 N.m {5.5 kgt m, 40 lbtftl
LOWER ARM
LOWER ARM EUSHING
a
---
SILICONE
@l GREASE
--
slLlcoNE
&l GREASE
1 8 - 3 5