Table of Contents
Advertisement
Dashboard
Replacement Precautions
SRS wire harnesses are routed near the dashboard and
s t e e n n g c o l u m n .
CAUTION:
a All SRS wire hsrnesses are covered wiih yellow insu-
lation. Before you disconnect any pan of an SRS wire
harness, disconnect the airbag conneclors.
a Whenever the ignition switch is ON (ll), or has been
tulned OFF for less than three minules, be careful not
to bump the SRS unit; the ai.bags could accidentally
deploy and cause damage or injuries.
a For additional precautions, refer lo the SRS sub-section
in section 23.
PASSENGER'S AIRBAG
Belore removing the dashboard:
1. Disconnect the battery negative cable, then discon-
n e . r
r h e
n ^ . i r i u a . a h l a
N O T E r T h e o r i g i n a l r a d i o h a s a c o d e d t h e t t p r o t e c ,
tion circuit. Be sure to get the customer's code num
ber before
-
disconnecting the battery.
-
removing the No. 47 (7.5 A) fuse from the under-
hood tuse/relay box.
-
removing the radio.
After service, reconnect power to the radio and turn
i t o n . W h e n t h e w o r d " C O D E " i s d i s p l a y e d , e n t e r
t h e c u s t o m e r ' s 5 - d i g i t c o d e t o r e s t o r e r a d i o
o p e r a t i o n .
DRIVER'S AIRBAG
SRS UNIT
20-138
2 . Install the short connectors (RED).
Driver's:
Remove the access panel, then disconnect the con-
nector between the cable reel and driver's airbag.
CABL€ REEL
CONNECTOR
--_--._-_-----
Front passenger's:
Remove the glove box (see page 20-137), then
disconnect the connector between the front pas-
senger's airbag and SRS main harness.
FRONT PASSENGER'S
AIRBAG CONNECTOR
SRS MAIN HARNESS
CONNECTOR
ORIVER'S AIRBAG
Advertisement
Table of Contents
Troubleshooting
