Table of Contents
Advertisement
Power Steering Gearbox
Reassembly (cont'dl
63. Install new boot bands on the boot and bend both
sets of locking tabs.
Lightly tap on the doubled-over portions to reduce
their height.
CAUTION: Stake ihe bsnd locking tabs tirmly.
Slide the rack right and ieft to be certain that the
boots are not deformed or twisted.
Install the right and left tie-rod ends on the rack
enos.
64.
lnstallation
CAUTION: Bo caretul not to bond or damrge the powcr
steering lines when in3t8lling the grlrbox.
1. Before installing the gearbox, slide the rack all the
way to right.
2,
Pass the right side of the stsering gearbox above
and through the right side of the rear beam.
3.
Hold the steering gearbox and slide the rack 8ll the
way to the right.
4.
Rsise the left side of the steering gearbox above
and through the left side of the rear beam.
5.
Install the pinion shaft grommet and insert the pin-
ion shaft up through the bulkhesd.
NOTE: Align the tab on the pinion shaft grommet
with the slot in the valve bodY.
oo.
tAa
1 7 - 5 8
Advertisement
Table of Contents
Troubleshooting
